Deskcnc key code6/11/2023 Are you using the serial port on both computers or are you using a usb to serial converter on either machine? If the blue light flashes, you might be getting a voltage sag or something or possibly the estop button is being pressed. If the file is in fact called default, you will have to overwrite the old file on th enew machine when copying it. You can open the file with notepad to make sure it is the file that has all the settings that you are looking for. Go into the deskcnc folder and find either the file default ini or if you saved your setting under a different name such as router, you can copy it to the same folder on the new machine. I re-hooked up my Desktop PC and ran the same g-code files with no problems. I even tried cutting air (no bit in the machine) and still the same thing. (servo fault) I have tried many g-code files and does the same thing. I get the blue flashing led light in my controller. I can cut for about 2 to 5 minutes, then it just stops cutting. (is there a file or something that I could copy from my desktop, rather then manually entering all the machine settings?) Everything works fine. I transfered all my settings from my desktop PC to the laptop. Hey All, Well, I tried my laptop with DeskCnc, with no luck.
0 Comments
Leave a Reply. |